White Bra

It took me a little time to figure out how to attach the bra on the back. Because of the kind of fabric I could not use velcro. I had a little attach similet to the one used in real bras. It is just perfect.
And again, a little piece of fabric from a kid tight, this is a perfect stretch and see-through fabric for lingerie.
Happy sewing!

Material
-       2 rectangles of  of kids tights 2 ¾ “ x 1 ¼ “ ( 7cm x 3cm)
-       2 Ribbons for the sleeves 3 ½ ” (9cm)
-       2 ribbons for the back of the bra 2” (5cm) – you can also use two rectangle of fabric.
Phase 1:
-       pleat the rectangles in 2
-       Devide the top of the fabric and draw two marks
-       Draw a line from each point till the curner of the fabric
-       Sew the fabric following the lines and cut the extra fabric
-       Reverse the triangles gently

Phase 2:
-       Sew one curner of the bottom of the two triangles together
-       Sew each sleeves on the top of each triangles

Phase 3 :
-       Sew the ribbons for the back
-       Add ons sew-on snap or an attach
-       Try it on the doll and sew the sleeves
-       Sew a little decoration on the middle of the bra

The bra is ready! Don’t forget to look for the panty that goes with it. It’s in the lingerie section.